Product Category:低压成套配电
Intro:GCS switchgear is according to the ministry in charge of the, the majority of power users and design department requirements, to meet the development of power market expansion, computer interfacing, power control, convenient installation and maintenance, such as shortening the time of accident treatment needs, in line with the principle of security, economic, reasonable and reliable design of new type low voltage draw-out switch cabinet can be used as the replacement of the low pressure draw-out switch cabinet. GCS switchgear with high ability of breaking, through good dynamic stability, electrical scheme is flexible and convenient combination, series, strong practicability, novel structure, high protection grade, etc. It - 1 "low-voltage complete switch equipment and control equipment", GB7251 "low-voltage complete switch equipment", EBK36001 standards such as the "low voltage draw-out switchgear.
GCS draw-out switch cabinet is suitable for power plants, substation, petrochemical industry, factories and mines enterprises, hotels, and high-rise buildings, such as low voltage power distribution system, power distribution and motor control center, capacitor compensation and electrical energy conversion, distribution and control.
In the large capacity of power plants, large-scale petrochemical industry such as low voltage power control center and situations of power use, such as motor control center can meet the special needs of the interface with the computer.

Ambient air temperature is not higher than 40 ℃, is not lower than 5 ℃. 24 hours shall not be higher than the average temperature 35 ℃ above, should be according to the actual situation let run.
Indoor use, use the site shall not exceed 2000 m above sea level.
Ambient air relative humidity, at the highest temperature of 40 ℃ less than 50%, at low temperature are allowed a larger relative humidity, such as at 20 ℃ at 90%, should be considered due to the change in temperature may accidentally condensation effect.
Switchgear installation with the inclination of the vertical plane does not exceed 5%, and the whole tank column relatively flat (GBJ232-82 standard).
Switchgear shall be installed in no violent vibration and impact, and enough to reduce electrical components are not due to corrosion